Skip to content
Free shipping from €350
France · EUR €
CARE AND MAINTENANCE

CARE AND MAINTENANCE

Care for your gear to maintain its performance and enjoy more time in the mountains.

GENERAL CARE

These recommendations apply to most technical outdoor clothing. Also check the specific care instructions for each material.

Machine washing

Always use a washing machine. Avoid hand washing: thorough rinsing is difficult and rubbing can damage seam tape and logos.

Temperature

Wash in cold water, at a maximum of 30°C.

Detergent

Use a neutral soap, preferably biodegradable.

Do not use

Never use fabric softener, which damages fabrics and accelerates garment ageing. Do not iron, steam or dry clean.

Preparation

Close all zips before washing. Avoid washing with hard-wearing clothing such as jeans with metal rivets, or place technical garments in a protective laundry bag to prevent abrasion.

Rinsing

Remove all detergent thoroughly. Run additional rinse cycles if necessary.

Drying

Air dry on a hanger without clothes pegs, which create points of tension.

Storage

Store garments laid flat or on wide hangers without sharp edges. Avoid keeping them folded or compressed in the same position for long periods.

SPECIFIC CARE

DOWN AND FEATHER INSULATION

Proper care of down-filled garments helps preserve their insulation, loft and useful life. Follow these steps to keep your jacket in good condition.

Preparation and washing

  • Close all zips before putting the garment in the washing machine.
  • Use a front-loading washing machine to protect the fabric. Wash the garment on its own or with very soft clothing.
  • Select a cold wash, using either a short programme or a dedicated down programme.
  • Use only a technical down cleaner such as Nikwax® Down Wash Direct. Do not hand wash, dry clean or use conventional detergents.
  • Remove dried mud or dust with a damp cloth before washing. For oil stains, apply a local stain remover and rinse that area thoroughly before washing the jacket.

Rinsing and spinning

  • Remove as much water as possible. When using the recommended cleaner, you can run up to three spin cycles.
  • Use a gentle spin at 500 rpm. Never exceed 600 rpm: excessive force can push down feathers through the seams.
  • If your washing machine has no spin function, lay the jacket flat on a surface and press it gently to release water. Never twist or wring it out.
  • If small down filaments emerge through the seams, leave them alone. Pulling one can draw out others.

Drying

  • Down will clump after washing. This is a natural response to absorbing water.
  • Tumble drying: You can use a tumble dryer at low temperature to avoid damaging synthetic fabrics or treatments.
  • Natural drying: Dry flat in the open air. This may take up to five days. Shake the garment and gently break up clumps by hand to redistribute the down throughout its baffles.
  • Body heat tip: The outer nylon fabric dries quickly. Once it is dry on the outside, put the jacket on and close the zips. Your body heat can help evaporate remaining moisture and restore loft over the following hours.

Maintaining water repellency DWR

  • Washing wears down the outer treatment that makes water bead off the fabric. After washing and drying, restore this layer with a dedicated down waterproofer such as Nikwax® Down Proof.

Correct storage

  • Hang the jacket in your wardrobe. This lets it breathe, release odours and retain its loft.
  • Down jackets can be compressed in a backpack during a trip, but must not be stored compressed for months. Long-term compression damages the down structure and its ability to trap heat.
WATERPROOF GARMENTS

Correct care of waterproof, breathable membrane garments such as eVent® or O2 helps maintain performance and prevents sweat, dirt and chemicals from degrading their properties.

Machine washing

  • Frequency: Wash regularly. Sweat, deodorant, make-up and sunscreen can contaminate the membrane and cause lasting damage if not removed.
  • Preparation: Wash the garment right side out, on its own or with other waterproof garments. Never hand wash: rubbing can damage the membrane and lift seam tape.
  • Settings: Use a cold wash cycle at 30°C.
  • Detergent: Use very small amounts of a liquid technical cleaner such as Nikwax® Tech Wash. Do not use fabric softener, bleach, or powder detergent, as these damage breathability.

Thorough rinsing

  • Run at least two rinse cycles. A poorly rinsed membrane can retain detergent in its pores and impair performance.
  • The garment should not smell of detergent after washing. If you notice a smell or foam in the drum, repeat rinse cycles without detergent until the water runs clear.

Drying and storage

  • Drying: Air dry in the shade on a hanger. Never tumble dry: heat can damage seam tape. Do not use clothes pegs, which create points of tension.
  • Storage: Keep the garment hanging in your wardrobe. Do not leave it compressed in a backpack for long periods at home.

Restoring the DWR finish

  • DWR is the outer treatment that makes water bead off the fabric. When it wears away, the outer fabric becomes saturated. Even if the membrane prevents water from entering, a saturated outer layer restricts moisture vapour from escaping, leaving you damp from condensation.
  • Reapplication: When water stops beading off the jacket, restore the finish in the washing machine using a PFC-free product such as Nikwax® TX.Direct Wash-In.
SYNTHETIC INSULATION
  • Frequency: Wash less often than next-to-skin layers such as T-shirts and thermal tops.
  • Spinning: Use a gentle spin cycle.
  • Inside out: Always turn the garment inside out before washing.
DWR WATER REPELLENCY

After around six to ten washes, the outer water-repellent treatment wears down. Reapply it with a suitable product such as Nikwax® SoftShell Proof, available as a spray or a wash-in treatment.

WOOL GARMENTS
  • Shrinkage: Although fabrics are pretreated, slight shrinkage after washing is normal.
  • Avoid heat: Do not iron. These garments often blend natural wool with technical synthetic fibres that can be damaged by direct heat.